how much is a new kia key fob to Replace a Kia Sportage Replacement Key

The key on many Kia models comes with the keyless entry feature built into. The key is usually akin to an electronic remote and can be replaced with a fresh one from a Kia dealer or locksmith.

Key fobs may stop working due to a variety of reasons, including the battery of the coin is dead, worn buttons signal interference, water damage and a malfunctioning receiver module. Here are some helpful tips on how you can get your Kia Sportage replacement key to work again.

How to replace the remote key or smart key

The battery inside your Kia's smart key will eventually need to be replaced, whether it's a remote key that starts with a push button or a standard metal key that doesn't have an electronic transponder. This is especially true if your car displays a message indicating that the smart or remote keys aren't powered.

It's a fairly simple procedure. In order to replace the battery in the key fob, remove the mechanical key from the hole in the back of the key fob. Then remove the cover. A small screw will be inside the key fob to hold the battery in the correct position. Using a small screwdriver, loosen the screw and pull out the battery that was in place. Then, insert the new one and close the hole in the key fob.

Test the key fob by pressing the lock and unlock buttons. It's good if the doors lock and unlock as you expect. You can now use the Kia's hands-free lock/unlock feature when your fingers are cold or you have to run some errands in Brandon.

Not all keys may require to be programmed (transponder chips or smart keys). This requires a machine for programming, which is only available to the locksmith who works for the automotive dealer. Other keys (non-transponder metal keys) don't require programming. If you need to reprogramme your key, you'll have to write down the key code's number on the key code tag.

how to unlock a kia optima without keys do I replace the battery?

If the Kia key fob is unable to respond to pressing the lock/unlock button, it's likely that the battery is depleted. A low battery can also cause other issues, like the check engine light turning on or the engine not cranking properly. Fortunately, replacing the battery on the key fob is a relatively simple DIY project that requires just a few tools.

Be sure to turn off your vehicle and close all doors prior to beginning. Find the small metal or a plastic piece at the bottom of the key fob. Press it until the key comes out. The key can be put into the door's driver handle to unlock your car.

To replace the key fob battery, take off the cover from the back and use a pry bar tool to loosen the latch holding the black negative battery cable. Remove the old battery and then orient the new one so that the "+" positive side is facing your face and the "-" negative side is facing the fob's metal electrical contacts. Push the new CR2032 battery straight into position and avoid excessive force to avoid damaging or breaking the contacts on the metal.

After installing the new battery after which you turn the key fob on and off in the ignition until the door locks up. You can then test the Kia's Key fob again to confirm that it is working correctly.

How to replace the smart key?

Depending on the model of your kia key fob replacement near me Sportage, you may have the standard key fob, or a smart key. The difference is that the smart key has a small mechanical key blade tucked inside it, while the standard fob doesn't. Both types of key fobs have a battery inside them that will eventually need to be replaced. This is a straightforward process that takes less than two minutes.

Before you get started before you begin, ensure that you are on a flat surface with good lighting and that your Kia is off. Also, remember that there are tiny parts inside the fob that could be snagged if not cautious.

The small release button is located on the lower backside. It can be a circular silver button or a rectangular slot. You can open the key fob by pressing the button.

After the key fob has been open, remove the battery. The new battery should be a CR-2032, and can be bought online or from your local auto parts store. After you've finished, your key fob will allow you to lock or unlock and start your vehicle, even if it isn't running.

How to replace the mechanical key for kia sportage

The Kia keyfob can be a fantastic convenience, allowing us to lock or unlock our car simply by pressing the button. But like any device, it can have problems occasionally. There are solutions to resolve these issues and keep your key fobs running for an extended period of time.

One of the most common issues is a low or dead battery. This can cause your device to stop working or operate intermittently. If this is the problem then replace the battery with a new one.

If this doesn't solve the issue, try using a standard flat-head screwdriver to break open the casing of the fob's plastic. Be careful not to damage internal components or scratch the plastic. After the battery has been removed, replace it with a new one.

After the new battery has been put in, close and open the doors using the mechanical key (every key fob in the kia has an emergency mechanical key that will fit into the slot). Test the key fob to verify that it's working properly. Contact a dealer, or a locksmith to solve the issue in the event that the fob is not working. Make sure they make you an emergency key that works for all trunk and door cylinders, to avoid lockouts again.