Peugeot 308 Key Fob Replacement

Peugeot's 308 could be catching on a little but it's still attractive. It might not be the plushest car in its class It's it's a Ford Focus or Volkswagen Golf will isolate you even better from road imperfections, but it's a relaxed and comfortable drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is persistent or intermittent the following tips will help.

Water Damage

When you accidentally leave your key fob in a puddle or splash it with water during kayaking, swimming, canoeing, rafting or canyoning, it's likely to be damaged by water. Keep your key fob in a dry bag whenever you go outside or engage in things that expose it to excessive amounts water.

It's also crucial to make sure that the fob is completely dried out prior to opening it to use it again. If you smell any odors emanating from the fob (such as industrial liquid or windshield washer fluid) This is a further indication that it's submerged.

A wet circuit board can cause the battery to dump its charge, or even explode. If you are able to get your 308 keyfob out of the water you need to turn the button side up and shake as much water out as possible before opening the casing. Once you have opened it, take off the battery and wipe the circuit board using an abrasive soaked in 90 percent isopropyl alcohol.

Other reasons why your Peugeot 308 remote keyless entry system may fail to function include a dead battery for your coin or receiver module issue signal interference, an electronic chip that is defective. If none of these causes the cause, you can try resetting the system by disconnection of the battery with 12 volts for approximately 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote-start system which allows the driver to start the car from a distance and then warm up or cool down the vehicle prior to entering. This feature is extremely useful, especially during cold winter months. However, it is possible that the remote start system stops working due to a variety of reasons, such as the battery of a coin that is dead.

A coin-shaped battery that is located inside the key fob will last a time of between two and four years, depending on how frequently it is used and the location where it was purchased. The date of use is typically written on the package or listed in the instruction manual.

If the key fob stops working after exposure to clean tap water, you should take the battery off, clean the electronic chip with a paper towel and isopropyl alcohol, and then dry it thoroughly before replacing it. If the key fob was exposed to soapy or salty water, it may have caused the chip to become damaged. It is necessary to replace it.

If you're not certain the battery is defective you can check its voltage with a multimeter that is set to the car's voltage range and connected to the terminals for minus and plus. If the voltage is lower than 12-13 volts you should replace the battery. You can also reset the computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should then start after this.

Faulty Receiver Module

If you don't see the "Key Detected" you might find the receiver module malfunctioning. It's the component which sends out the signal when your key fob goes off. It also functions as an alarm and blocks the car from starting if it doesn't have the correct key.

This can be due to many reasons, such as water damage or simply aging. If your Peugeot 308 key fob was exposed to dirty tap water, like, the electronic chip inside is damaged. In this situation, you'll need to remove it and clean it thoroughly using isopropyl or electronic cleaner. Once it's dry, you can put the battery back in and try it again.

If the problem persists it is recommended to visit an area Peugeot expert or locksmith. They can use an instrument for diagnosing to pinpoint the problem and fix it.

It can be a stressful experience to lose your peugeot 206 key fob and reprogramming car key. However, a professional auto locksmith can address the issue in just a few minutes. They can program your car key cover peugeot and cut a new, working key for you. Click here to find a local locksmith near you.

Faulty Electronic Chip

The electronic chip in your Peugeot 308 key fob is an important component of the remote control system. If it is damaged your car might not start or you might get a message saying "anti-theft active". If this occurs, the only way to fix the problem is to purchase a new key. Auto locksmiths with experience are able to offer the service in the shortest time.

The chip in your peugeot boxer key 308 key fob can be damaged due to sweat, water damage dirt, or other causes. If your Peugeot 308 key fob is exposed to soapy water, clean it immediately. You can clean the electronic component using a paper towel soaked in isopropyl Alcohol. Then, you need to let the battery dry completely.

Sometimes keys may be inoperable due to radio interference. This is usually caused by other devices operate on the same frequencies as your peugeot 107 replacement key keyfob. This could be due to bad conditions or objects in the vicinity of the vehicle. If you have this issue it is recommended to visit a Peugeot dealership.

The peugeot 208 key programming instructions Key Fob 207/308 is fragile and requires special attention. It is not recommended to drop it or throw it around. If you lose it, try to locate it as quickly as is possible. You can reset all on-board computers by disconnecting the 12 volt battery for a short period of time. Disconnect the negative cable prior to the positive.